|
BDSM Clips and Clamps
Definition
A nipple clamp is a clamp used to
stimulate the nipples by applying varying degrees of pressure. Its basic
principle relies on restriction of blood flood to the erect nipple. They are
often used in certain BDSM activities, on both men and women. The use of nipple
clamps is often potrayed in the media as deviant or kinky sexual behavior.
Tweezer clamp - consists of
two short lengths of metal, no more than 5–10 cm (2–4 in) in
length. The ends are curved slightly to improve their ability to grip the
nipple. Typically, they have a small 1 cm rubber sheath over this end to
protect the nipple from damage. A small ring wraps around the two pieces of
metal and is used to adjust the tension. The user places the two sides of the
metal head either side of the nipple, then by sliding the ring along the clamp
shaft towards the nipple, causes the two halves to close tighter together.
Tension can thus be adjusted depending on the location of the ring — the
closer the ring is along the shaft toward the nipple, the tighter the clamp.
Clover Clamp - also
referred to as a "butterfly clamp", is of Japanese design and has the
ability to provide increasing tension if pulled on. The clamp itself is flat,
but about 10 cm by 5 cm in size. Using spring tension, the clamp is
applied to the nipple and the tension of its spring holds the clamp in place.
This clamp usually provides a very high pain level, and is usually only used by
more advanced users. To increase tension on the nipples, small weights such as
fishing line sinkers can be attached to the ends of the clamp. As increased
pulling tension is applied to the clamp, it will cause the jaws of the clamp to
close tighter depending on the amount of pull pressure
Toys Used During This Activity
Brought to you by BDSM-gear
Additional Resources
How
to Use Clothespins
How
to safely use nipple clamps
The
Big O: Toys for boys
Clothespin FAQs
| 
